The mold closing size of sewage well can be determined according to the customer's demand, generally 700mm, and the national standard well cover is 700mm. Gate well steel mold sales is relatively small, but a lot of municipal engineering is inseparable from the gate well, because the gate well steel mold size specification is relatively large, so I plant to provide and after-sales service.
The total height of mould for sewage well is 150cm, the height of steel mould for wellhead is 50cm, the height of steel mould for sewage sluice well is 100cm, the inner diameter of sewage sluice well is 100cm, and the outer diameter is 120cm. Usage of steel mould for sewage sluice well: first spray a layer of engine oil into the inner cavity of steel mould for sewage sluice well. For the convenience of demoulding, then pour the mixed cement into the mould and vibrate it with a vibrator. Demoulding can be done after the initial solidification of cement. It takes about 24 hours, and the operation is very simple.
When using the sewage well mold, the specific use method is very simple. Put the concrete directly into the sewage inspection well mold and the circular sewage inspection well mold, and form the mold by vibrating the platform. After 24 hours, the mold can be demoulded. However, under normal circumstances, the demoulding time is relatively long when the weather is relatively cold. Although the operation is relatively simple, it still needs a certain amount of time skill. In order to better realize the rapid development of sewage inspection well mold and cast-in-place sewage inspection well mold, we should integrate and make good use of circular economy and green manufacturing in the mold production process, and use as few resources as possible to create as much value as possible in the mold production process, so as to realize the recycling of mold.